- Joined
- Mar 3, 2015
- Messages
- 13
- Reaction score
- 0
Hi,
I have done the Firmware v1.2.0.17 update today.
After copyed the BIN file in the micro SD card, connected camera to the drone, the remote control and apps ON, the update started without asking me nothing. After 1 hour the drone was still updating so I decided to OFF the drone.
After that I put a USB key on the Master and Slave remote controls, the update works fine in the Slave but didn´t achieve in the Master.
Now the master can't connect to the drone and I'm not sure that the update of the Inspire 1 is correct.
I would like to know if there is a way to hard reset the remote control and the drone.
Thanks in advance,
Olivier.
I have done the Firmware v1.2.0.17 update today.
After copyed the BIN file in the micro SD card, connected camera to the drone, the remote control and apps ON, the update started without asking me nothing. After 1 hour the drone was still updating so I decided to OFF the drone.
After that I put a USB key on the Master and Slave remote controls, the update works fine in the Slave but didn´t achieve in the Master.
Now the master can't connect to the drone and I'm not sure that the update of the Inspire 1 is correct.
I would like to know if there is a way to hard reset the remote control and the drone.
Thanks in advance,
Olivier.