Adding a second camera on the Inspire 1 is needed from my side to use the Inspire 1 in dual operator mode.
So the pilot can focus on flying and monitor where the Inspire 1 is flying. On the other hand the camera operator can fully focus on the subject to get captured.
Therefore I wanted to add a FPV camera into the nose of the Inspire 1 and add an OSD module to get the most important information on the FPV screen.
The components I've got are:
- FPV camera SH6 Pro (SH6 Pro FPV Camera)
- FFOSD N3 v2 with CAN port (FFOSD N3 V2 OSD Module DJI Phantom CAN Port OSD Replace DJI IOSD Mini $30.98 Free Shipping @GoodLuckBuy.com)
Unfortunately the OSD board was not able to decode the CAN messages from the Inspire controller.
Did someone manage to get a FPV camera working on the Inspire 1 with OSD information?
Would be very interested in more information about that and share my experience.
Cheers
So the pilot can focus on flying and monitor where the Inspire 1 is flying. On the other hand the camera operator can fully focus on the subject to get captured.
Therefore I wanted to add a FPV camera into the nose of the Inspire 1 and add an OSD module to get the most important information on the FPV screen.
The components I've got are:
- FPV camera SH6 Pro (SH6 Pro FPV Camera)
- FFOSD N3 v2 with CAN port (FFOSD N3 V2 OSD Module DJI Phantom CAN Port OSD Replace DJI IOSD Mini $30.98 Free Shipping @GoodLuckBuy.com)
Unfortunately the OSD board was not able to decode the CAN messages from the Inspire controller.
Did someone manage to get a FPV camera working on the Inspire 1 with OSD information?
Would be very interested in more information about that and share my experience.
Cheers