Hi there, I too have bought this battery connector, with the cable that allows connection of 2 batteries with XT60 connector into the single XT60 connector on the battery mod clip connector.
So far, probably due to ignorance of LiPo Batteires and lack of patience, I have not faired too good. I bought 2 x 6s 1300mha 22 volt nanotech batteries from hobbyking.
So far I have shorted both batteries (a bang and some smoke!) when connecting them to my Inspire 1 Pro. The i1 Pro is OK, thankfully.
I have tried to get some definite guidance from the battery mod clip supplier, on the order/procedure for connecting the mod clip, connecting cable and external batteries and powering on the i1, but just get vague replies.
So if you could let me know how you connect it all up without the battery going bang! It would be appreciated. If you have knowledge on compatable batteries, that would be appreciated too, I'm more
Concerned with redundancy at the moment, so if main battery fails, the externals allow for a landing. I want keep the weight down, can a pair of 3s 2200mha 11.5 volts be used as I have a lot of them from a previous bird
This is an interesting subject and if I can get it to work, may avoid the need upgrade
i2 .
Thanks
Sent from my iPhone using
InspirePilots